If we can we start from scratch I might be able to help after a couple of e mails.
Put all the wires back to their original position. What happens when you turn it on?(describe symptoms) The information I will need is: Does the steam boiler heat up? Does the big red light on the right side of the machine go on? What do the display on the PID say? Is the small light on the PID flashing? Does the pump run when you raise the brew lever? Todd Salzman Whole Latte Love On Sun, Mar 22, 2015 at 6:40 PM, Bruce Keeler <[email protected]> wrote: > BII with rotary and PID conversions installed. > > When the machine is warmed up and steam light is off, I see 110V at BOTH > terminals of the brew boiler element. This tells me that the neutral > connection to the element is bad, right? When the steam boiler is getting > power I see 110V and 0V at its terminals as expected. > > But the thing is, with the machine powered down I stripped a tiny piece of > insulation off the neutral wire of the incoming power cord and measured the > resistance from there to each of the two element terminals. I got 0Ω and > 14Ω as expected. This tells me that the neutral connection to the element > is fine. > > I'm going crazy trying to figure this out. Any ideas? > > Thanks, > Bruce > > -- > You received this message because you are subscribed to the Google Groups > "Brewtus" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at http://groups.google.com/group/brewtus. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
