Sounds like the switch is sticking. A drop of lube on the shaft behind 
lever where the wheel follows the arc would be my first thought. It happens 
on mine once in a while too. 

On Monday, October 13, 2014 at 5:21:09 PM UTC-5, Rieka S wrote:
>
> Hello,
>
> I have a Brewtus II and I recently replaced both a leaky OPV and then the 
> Ulka vibe pump. Since then, I am unable to get the brew consistent pressure 
> as I used to when I had the machine completely dialed in for beautiful 
> shots. 
>
> First, the pressure was varying up and down during brew cycle, and after 
> turning the OPV adjustment up and down all the way several times, the 
> pressure now is mostly steady during a shot. However, when the wand is 
> pulled down to complete the shot, the water in the brew head is not 
> completely expelled, and the machine brew pressure gauge holds steady at 
> the brew pressure of around 9 bars. For the pressure to drop down to 1-2 
> bars, I have to quickly lift the wand up and down again, and let little 
> water drain out of the group head drain.
>
> This behavior is also evident when back flushing - earlier the back flush 
> ended with a strong "whooosh!" and expelled the water with considerable 
> force from the drain. Now, the outflow of the water from the drain is not 
> strong, but ends more with a slow stream. Again, the pressure is not strong 
> enough when the brew wand is pulled down again.
>
> The spent grounds in the portafilter loose and watery top surface - not 
> like a dry puck that I used to have earlier.
>
> Any thoughts on how I can solve this pressure problem? I have made sure 
> the water lines are not kinked, I have also replaced the rubber gasket in 
> the group head sieve.
>
> Any thoughts/help much appreciated! My shots are nowhere near the 
> beautiful ones I used to have!!
>
> Ken.
>
>
>
>
>

-- 
You received this message because you are subscribed to the Google Groups 
"Brewtus" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send email to [email protected].
Visit this group at http://groups.google.com/group/brewtus.
For more options, visit https://groups.google.com/d/optout.

Reply via email to