Awesome Ken, thank you. Unfortunately, or fortunately, I have sold the machine so hopefully the new owner finds this helpful. I have directed him to this site
On Monday, January 18, 2016 at 5:09:48 PM UTC-8, ken k wrote: > > You will need to program the controller after you receive it. If you > purchase it from Furneco, it is usually set up for "cold" and not "heat". > It is easy to change it with the provided programming instructions---I > think P0 is changed from 0 to 1. Some of the other parameters may need > changing. If you need those parameters, just post a request . Also, while > the controllers in the Brewtus units supplied to WLL hid the temperature > overshoot, the replacement controller will not, so don't be surprised if > the temp climbs to 98 or 99 before heading back down... > > This was some very helpful advice from Rob Combs: > > "Programming is pretty easy. > With the unit powered on: > Press both arrow up and arrow down buttons for about 10 seconds the > display will indicate programming parameter C0. > Press the set button once. > Press down arrow key until the display reads -5. Press set > Press up arrow until display reads C1 > Press set > press up arrow until display reads 1 > Press set > Press up arrow until display reads C2 > Press set > Press up arrow to +99 > Press set. > > Same process for each parameter > C3 = -45 > C4 = 1 > C5 = 0 > C7 = 0 > C8 = 1 > d0 = 1 > d1 = 0 > d2 = 2 > d3 = 5 > L5 = 0 > L6 = 0 > PU = 0 > P0 = 0 --- The only thing is that I think this is an error and should be > "1", not 0 > P1 - P7 = 0 > EP programming exit point - press set . > > Take your time, mind your wiring plan and it's a 5 to 10 minute job. " > > > > > > On Sunday, January 17, 2016 at 4:05:46 PM UTC-8, Jenni Moser wrote: >> >> Need to replace the temp probe for my original Brewtus. Would prefer not >> to have to upgrade to PID at this point, just want to get my machine up and >> running. >> Anybody know where to look? >> thanks, Jenni >> > -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
