sold? good idea. On Mon, Feb 1, 2016 at 3:47 AM, Jenni Moser <[email protected]> wrote:
> Awesome Ken, thank you. Unfortunately, or fortunately, I have sold the > machine so hopefully the new owner finds this helpful. I have directed him > to this site > > > On Monday, January 18, 2016 at 5:09:48 PM UTC-8, ken k wrote: >> >> You will need to program the controller after you receive it. If you >> purchase it from Furneco, it is usually set up for "cold" and not "heat". >> It is easy to change it with the provided programming instructions---I >> think P0 is changed from 0 to 1. Some of the other parameters may need >> changing. If you need those parameters, just post a request . Also, while >> the controllers in the Brewtus units supplied to WLL hid the temperature >> overshoot, the replacement controller will not, so don't be surprised if >> the temp climbs to 98 or 99 before heading back down... >> >> This was some very helpful advice from Rob Combs: >> >> "Programming is pretty easy. >> With the unit powered on: >> Press both arrow up and arrow down buttons for about 10 seconds the >> display will indicate programming parameter C0. >> Press the set button once. >> Press down arrow key until the display reads -5. Press set >> Press up arrow until display reads C1 >> Press set >> press up arrow until display reads 1 >> Press set >> Press up arrow until display reads C2 >> Press set >> Press up arrow to +99 >> Press set. >> >> Same process for each parameter >> C3 = -45 >> C4 = 1 >> C5 = 0 >> C7 = 0 >> C8 = 1 >> d0 = 1 >> d1 = 0 >> d2 = 2 >> d3 = 5 >> L5 = 0 >> L6 = 0 >> PU = 0 >> P0 = 0 --- The only thing is that I think this is an error and should >> be "1", not 0 >> P1 - P7 = 0 >> EP programming exit point - press set . >> >> Take your time, mind your wiring plan and it's a 5 to 10 minute job. " >> >> >> >> >> >> On Sunday, January 17, 2016 at 4:05:46 PM UTC-8, Jenni Moser wrote: >>> >>> Need to replace the temp probe for my original Brewtus. Would prefer not >>> to have to upgrade to PID at this point, just want to get my machine up and >>> running. >>> Anybody know where to look? >>> thanks, Jenni >>> >> -- > You received this message because you are subscribed to the Google Groups > "Brewtus" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at https://groups.google.com/group/brewtus. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
