Jason, Did you find the right part? Have same problem with my Office Lever.
On Tuesday, April 2, 2019 at 11:52:26 AM UTC-5, Jason Brechin wrote: > > A leak developed where the PTFE tubing brings water from the pump toward > the boilers. Going in to part 5 on page 18: > https://wiki.wholelattelove.com/images/2/24/BREWTUS_IV_Parts_Diagram.pdf > > The diagram has part number 30400020, a 2-piece elbow with a part that > screws over the PTFE tube pushed onto a male tip. The part in my machine > was a push-to-connect fitting, as shown on WLL (currently out of stock): > https://www.wholelattelove.com/products/expobar-elbow-replacement-kit > > The tech support suggested that the push-to-connect elbow fitting was the > newer part, but mine mechanically failed. After attempting to re-seat the > tube, the ring you push in to release the tube fell out/off the elbow. > > While this is carrying "cold" water, it seems to be a "hot" area, > conducting a bit of heat from the boiler above. Can this be replaced with > any other fitting or type of connection? Do the "old" elbows offer better > reliability despite not being push-to-connect? Has anyone replaced this > section with braided stainless or other alternatives? > > Thanks, > Jason > -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/brewtus/4c314477-413e-4854-a30a-5daaef03493c%40googlegroups.com.
