> > Eric, > Thanks, Where are the overtemp cutoff switches? I should look at them.
I had bought a pack of 100 vac relief o-rings from Amazon that are supposed to be good at 400 degrees. I replaced 1. I recently replaced the pressure stat. I had rebuilt my brew head earlier this year with a kit of springs & seals from WLL. Did not solve the reason I did that. Instead I found a loose wire going into the PID that was the problem . I have checked the brew leverl seal. My PID screen is starting to lose segments from first digit. Not a big problem. I ordered a new pump assembly kit a few days ago. Brew pressure during shots is oscillating. Goes up to 9 and then down to 5 and then back to 9. I suspect the pump is starting to fail. -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/brewtus/537775dd-c2f5-45df-a4c0-53b8c661f098%40googlegroups.com.
