Sunday, September 13, 2020, 9:20:31 PM, you wrote:
| I don't believe that any of the surfaces are damaged, but I will take a closer look at the two mating surfaces. There does seem to be a natural place for a gasket behind the head of the tapered fitting. I wonder if one could be added. |
If those fittings are in good condition, properly aligned and tightened, there is no need for any gasket material. A thin teflon flat washer between the mating surfaces may help when the faces will not quite seal. It should not be necessary, but when all else fails, it may solve the problem.
-- Ira --
You received this message because you are subscribed to the Google Groups "Brewtus" group.
To unsubscribe from this group and stop receiving emails from it, send an email to [email protected].
To view this discussion on the web visit https://groups.google.com/d/msgid/brewtus/1975691930.20200913215535%40gmail.com.
