Hi,

Could you possibly be experiencing a problem with the steam boiler 
thermostat? If it is tripping, then the steam boiler and light will lose 
power and the pStat will never get any pressure build up, so the brew 
boiler wont get power. You could test the thermostat by measuring voltage 
across it during heating up. It should remain at around 0VAC the whole 
time. If you notice any appreciable voltage across it, then it is going 
open circuit and stopping your boiler from receiving power.

Cheers,
Aaron

[image: Steam Boiler Thermostat.jpg]

On Monday, February 1, 2021 at 11:12:39 AM UTC+11 [email protected] wrote:

> Greetings Ira,
>
> Yes indeed I do have a voltmeter. I tried testing the voltage at the 
> pressure stat. When the steam boiler was off, I was getting a steady 115V 
> to the brew boiler. So far so good. When the steam boiler engaged, the 
> voltage to the brew boiler dropped to zero. Also, so far so good. However, 
> the voltage to the steam boiler would bounce around from 115V to 85V to 3V, 
> back up to 115V etc. Another odd thing...when the steam boiler thought it 
> was 'hot enough', I tried rotating the ring on the pressure stat clockwise. 
> This *should* have re-engaged the steam boiler to increase the pressure. It 
> did not do that. Even odder (perhaps), earlier today, the steam pressure 
> would not get above 0.4 bar. Trying again,  later tonight, steam pressure 
> would get up to 1.2 bar. Even at 1.2 bar, I could not get the steam 
> pressure to increase by rotating the ring on the pressure stat.
>
> Thanks as always for your thoughts Ira,
>
> Rich...you had a good thought there and is does make sense. I have the 
> cover off of the unit and still wasn't helping. I wish it did since your 
> comments were a good theory..
>
> On Sunday, January 31, 2021 at 5:52:50 PM UTC-6 Ira wrote:
>
>> Hello winnipegger65,
>>
>>
>> Sunday, January 31, 2021, 2:05:09 PM, you wrote:
>>
>>
>> I was wondering if this is a bad pressure stat. I replaced the pressure 
>> stat just over a year ago and would think they would last longer than a 
>> year. Any ideas from you out there? 
>> Do you own a voltmeter or a neon test light?
>>
>> -- Ira
>>
>

-- 
You received this message because you are subscribed to the Google Groups 
"Brewtus" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To view this discussion on the web visit 
https://groups.google.com/d/msgid/brewtus/67947771-df04-41b9-85e1-5053620f5992n%40googlegroups.com.

Reply via email to