I found three docs at HB. Brewtus Compendium, Brewtus Operating manual and OPV doc. Will be helpful. So far I just see a brew group pressure gauge as a change for Brewtus II.
On Tuesday, March 16, 2021 at 9:10:29 PM UTC-7 Roger wrote: > Hi all. Just picked up a Brewtus II. Probably sat in a shed several > years. Was plumbed in previously. The lid to water reservoir missing. (??) > I assume a tube could have run from where the braded hose is connected to > the top of the water reservoir if using internal storage?? If I just jumper > the reservoir switch wires and put the end of braided hose in a container > would it work? Is there a change over switch or anything to change if > changing from pressurized direct to atmospheric storage tank? Also the > previous owner said it wouldn't heat, that's about all I know. I'm thinking > to jumper both thermal switches for testing. Other ideas for me? I guess > mainly I want to ensure I get water in the two boilers. Have retrofitted a > couple of simple lever machines in the past 6 months, so that's my > experience level, but I feel I can get it done what ever the problem is, > just looking for a little bit of direction to start to save research time > and a link to manual if anyone has a link. I did see some things on HB that > pointed to a area where documents might be, but seems to be taken down. > Thanks![image: PXL_20210317_040736568.jpg][image: > PXL_20210317_040745913.jpg] -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/brewtus/02e7e375-1feb-4d13-a661-8a9120f17792n%40googlegroups.com.
