On Wed, Nov 05, 2008 at 10:35:55AM +0100, Sebastijan Šilec wrote:
> Hello
> We were using a quadbri card from Junghanns, and now bought openvox b800p
>
> I tried to compile briistuff with openvox qozap patch but no luck....
>
> [EMAIL PROTECTED]:~# ztcfg -vvvv
>
> Zaptel Configuration
> ======================
>
> SPAN 1: CCS/ AMI Build-out: 133-266 feet (DSX-1)
> SPAN 2: CCS/ AMI Build-out: 133-266 feet (DSX-1)
> SPAN 3: CCS/ AMI Build-out: 133-266 feet (DSX-1)
> SPAN 4: CCS/ AMI Build-out: 133-266 feet (DSX-1)
> SPAN 5: CCS/ AMI Build-out: 133-266 feet (DSX-1)
> SPAN 6: CCS/ AMI Build-out: 133-266 feet (DSX-1)
> SPAN 7: CCS/ AMI Build-out: 133-266 feet (DSX-1)
> SPAN 8: CCS/ AMI Build-out: 133-266 feet (DSX-1)
>
> Channel map:
>
> Channel 01: Clear channel (Default) (Slaves: 01)
> Channel 02: Clear channel (Default) (Slaves: 02)
> Channel 03: D-channel (Default) (Slaves: 03)
> Channel 04: Clear channel (Default) (Slaves: 04)
> Channel 05: Clear channel (Default) (Slaves: 05)
> Channel 06: D-channel (Default) (Slaves: 06)
> Channel 07: Clear channel (Default) (Slaves: 07)
> Channel 08: Clear channel (Default) (Slaves: 08)
> Channel 09: D-channel (Default) (Slaves: 09)
> Channel 10: Clear channel (Default) (Slaves: 10)
> Channel 11: Clear channel (Default) (Slaves: 11)
> Channel 12: D-channel (Default) (Slaves: 12)
> Channel 13: Clear channel (A-law) (Slaves: 13)
> Channel 14: D-channel (Default) (Slaves: 14)
> Channel 15: Clear channel (A-law) (Slaves: 15)
> Channel 16: D-channel (Default) (Slaves: 16)
> Channel 17: Clear channel (A-law) (Slaves: 17)
> Channel 18: D-channel (Default) (Slaves: 18)
> Channel 19: Clear channel (A-law) (Slaves: 19)
> Channel 20: D-channel (Default) (Slaves: 20)
>
> 20 channels configured.
In later versions of Zaptel this misleading message was replaced with:
"[20] channels to configure."
Up to this point it only showed what you wrote in zaptel.conf .
>
> ZT_SPANCONFIG failed on span 1: No such device or address (6)
Oops . No span 1 .
Do you actually see the card on lspci? Is the module loaded?
>
> I get this error.
>
> Any suggestions how to make an easiest transition between two cards?
> We have bristuff-0.3.0-PRE-1q installed
There are newer versions of bristuff available.
--
Tzafrir Cohen
icq#16849755 jabber:[EMAIL PROTECTED]
+972-50-7952406 mailto:[EMAIL PROTECTED]
http://www.xorcom.com iax:[EMAIL PROTECTED]/tzafrir
_______________________________________________
Bristuff-users mailing list
[email protected]
http://lists.three-dimensional.net/mailman/listinfo/bristuff-users
