[quoted lines by Jason White on 2020/12/06 at 11:43 -0500] >I installed the latest BRLTTY 6.2 pre-release code from Git master. I also >ran "make install" for both the udev and systemd components.
Did you also do make reload (which does the commands I gave earlier) in both, or did you reboot (in which case you don't need to do those)? >The result now is that BRLTTY starts successfully, detects the braille >display, but then stops later in the boot process with a "BRLTTY stopped" >message on the display. About how much later? Could you attach your udev rules to a reply? >The journal shows that systemd is stopping the BRLTTY >instance (with no reason given, as before). this might be a udev rules problem, unless systemd is doing something new and I'm using an older release of it than you are. I'm using 248. -- I believe the Bible to be the very Word of God: http://Mielke.cc/bible/ Dave Mielke | 2213 Fox Crescent | WebHome: http://Mielke.cc/ EMail: [email protected] | Ottawa, Ontario | Twitter: @Dave_Mielke Phone: +1 613 726 0014 | Canada K2A 1H7 | _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: [email protected] For general information, go to: http://brltty.app/mailman/listinfo/brltty
