06.12.2020 19:54, Dave Mielke пишет:
[quoted lines by Jason White on 2020/12/06 at 11:43 -0500]
I installed the latest BRLTTY 6.2 pre-release code from Git master. I also
ran "make install" for both the udev and systemd components.
Did you also do make reload (which does the commands I gave earlier) in both,
or did you reboot (in which case you don't need to do those)?
The result now is that BRLTTY starts successfully, detects the braille
display, but then stops later in the boot process with a "BRLTTY stopped"
message on the display.
About how much later?
Could you attach your udev rules to a reply?
The journal shows that systemd is stopping the BRLTTY
instance (with no reason given, as before).
this might be a udev rules problem, unless systemd is doing something new and
I'm using an older release of it than you are. I'm using 248.
hm. the latest release of systemd 247. are you using dev version?
--
Sincerely, Alexander.
_______________________________________________
This message was sent via the BRLTTY mailing list.
To post a message, send an e-mail to: [email protected]
For general information, go to: http://brltty.app/mailman/listinfo/brltty
