Hi John, Sounds like it would do the trick. How much does the boring bar you have in mind cost? I know they vary quite a bit. I wouldn’t mind making the drive if nobody closer can help.
I’m actually looking for a machine for my garage right now. Something with a decent capacity. Something with a 5’ bed with a 6-8” swing. Single phase. Not sure if you know anyone selling used. 73, Mike Giannaccio W5REZ > On May 5, 2022, at 2:44 PM, john Parmalee via BVARC <[email protected]> wrote: > > > Mike I think my 1939 South Bend 9" would do it. However I am north of 99 > where it turns East. Just barely in SW Montgomery county. I don't have a > boring tool that would do the job. I might let you buy me a boring bar. How > deep do we have to go? > > John Parmalee > [email protected] > 281-380-3811 > K5VGM WI2XLJ > In a message dated 5/5/2022 2:23:37 PM Central Standard Time, [email protected] > writes: > > Does anyone have access to a lathe? I have two Delrin parts I need to remove > 10 thousandths from the bore. Would need to be able to hold a 2.25” piece. > Willing to pay for the service of course. > > Thanks! > > 73, > > Mike Giannaccio > W5REZ > > ________________________________________________ > Brazos Valley Amateur Radio Club > > BVARC mailing list > [email protected] > http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org > Publicly available archives are available here: > https://www.mail-archive.com/[email protected]/ > ________________________________________________ > Brazos Valley Amateur Radio Club > > BVARC mailing list > [email protected] > http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org > Publicly available archives are available here: > https://www.mail-archive.com/[email protected]/
________________________________________________ Brazos Valley Amateur Radio Club BVARC mailing list [email protected] http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org Publicly available archives are available here: https://www.mail-archive.com/[email protected]/
