Hi Rishi,
When segmenting a partial hemisphere, it is necessary to identify the
location of the cut that separates the partial hemisphere from the
remained of the cortex so that "padding" may be added. You will need
to load your segmentation volume and start the segmentation process
with the input volume being your segmentation volume. On the
Segmentation Operations page, make sure Automatic Error Correction is
NOT selected. Sometime after pressing the Next button the Partial
Hemisphere Padding Dialog will pop up. Check the "Negative Y
(Posterior)" box since you are processing (I believe) a frontal lobe.
This will artificially extend the frontal lobe so that it can be
flattened. When a surface is generated, the paint file will identify
this artificial extension as "CUT.FACE". When you get the error
message about "Paint Names are not in Paint File", this is due to the
CUT.FACE nodes not being found.
----------------------------------------------------------
John Harwell
[EMAIL PROTECTED]
314-362-3467
Department of Anatomy and Neurobiology
Washington University School of Medicine
660 S. Euclid Ave. Box 8108
St. Louis, MO 63110 USA
On Nov 5, 2005, at 9:57 AM, Rishi Kalwani wrote:
Hi,
So I'm trying to Flatten a Partial Hemisphere (a frontal cortex, Type:
Ellipsoid) in caret5 and am running into the following error:
Paint Names are not in Paint File
This is before it even begins to flatten. I looked at the
geography.paint file loaded and the tag-number-of-paint-names is 6,
and they are as follows.
0 ???
1 SUL
2 CENTRAL
3 DEEP_SUL
4 CALCARINE
5 GYRAL
Assuming that these are the appropriate and sufficient number of paint
names, I don't know why I get this error......Any suggestions for what
I might edit? thanks
Rishi
_______________________________________________
caret-users mailing list
caret-users@brainvis.wustl.edu
http://pulvinar.wustl.edu/mailman/listinfo/caret-users
