hi glenn,
do you have a parallel download cable you can try?
(not USB)
dan
G Jones wrote:
Hello,
I'm trying to burn my design into the PROM of my iBOB. I've struggled
with this before, but usually after several iterations I finally get it
to work. Any ideas why this is so finicky? I am using a Platform USB
cable, and the PROM verifies fine, so I think it's programming the file
OK. I suspect the file creation. However I'm using the exact version of
iMPACT shown in the iBOB PROM programming guide and following the steps
exactly. The problem is that the FPGA fails to program (the DONE light
does not go on, nor any of the other LEDs I expect from the design when
it's working (the serial port is also unresponsive of course). I've
tried pushing the prog button, but no help there. If I program the
design to the FPGA directly, it starts up immediately. Any suggestions
of what I might be missing?
Thanks,
Glenn
