Hi, I tried compiling a design that's exactly tut2 except it uses gbe ports 1 and 2, and that didn't work on the problem roach either, but that design did work on other roaches.
This very same bitstream has worked on this board in the past, which the really mystifying part. I'll take a look at the 10gbe link status register and those u-boot tests. On Fri, Apr 1, 2011 at 2:33 AM, David George <[email protected]> wrote: > Hi Jon. > > I would check the 10Ge link status register. It sits at an offset of > 0x24 in the 10Ge register. It should be equal to 0x7e or 0x7c. If it > equals one of these values the controller and link are working fine. > > Has this same bitstream worked on the same board before? I have on > rare occasions I have seen compiles that produced 10ge bitstreams that > would work on some boards and not others. If this is the case I would > try recompiling. Have other people seen this issue? > > It is a little unlikely that there is a hardware failure, but you can > run the Built-in tests from u-boot to ease your mind. Have a look at > the FPGA Configuration and Testing section. > > http://casper.berkeley.edu/wiki/ROACH_Bringup#FPGA_Configuration_and_Testing > > Kind regards, > David >
