Hello Ryan,
This happened to me as well recently with a new ROACH board. I
noticed that the file '/etc/network/run/ifstate' was corrupted. When I
used the command 'ls -alh' all I got was question marks in each field. I
was unable to rm or mv the file, or even execute 'touch ifstate'.
Another ROACH board that I received in the same shipment worked right
out of the box. I was going to try completely formatting the troublesome
SD card and copying everything on the working SD onto it. I have not
tried this yet, though...but I think it should work.
-Louis P. Dartez
Arecibo Remote Command Center Scholar
Center for Advanced Radio Astronomy Researcher
Department of Physics and Astronomy
University of Texas at Brownsville
On 09/10/2012 06:42 PM, Ryan Monroe wrote:
Hi All,
We recently purchased two ROACH boards from Digicom and we seem to be
experiencing a bit of an issue. Upon trying to boot to the SD card on
either, several processes don't come up, complaining of "Stale NFS
handle". If I configure eth0, I can start it that once but it will
not initialize by default. Attached is a copy of a dump from minicom
via serial.
The only command I am using in uboot is mmcboot. In addition, I'm
using the SD cards as they arrived (which seems to have the correct
filesystem/format). Should I be doing something else in addition to
mount the SD card?
Finally, I saw a similar thread in the archive (here)
<http://www.mail-archive.com/[email protected]/msg00612.html>.
Any advice? Thank you very much!
--Ryan
