I'll just chime in that I've seen this error before, which I solved by
switching to a different version of the library. I can't help with this
one, just wanted to say it's probably not operator error.
--Ryan
On 12/20/2012 01:24 PM, katherine viviana cortes urbina wrote:
Hi Mark,
Today I change the fft in my design , I also open up the parameter
boxes of both and make sure that the parameters are the same, I delete
the old and replace it with the new, but I have the same error,
Detected Linux OS
#############################
## System Update ##
#############################
Error using ==> gen_xps_files at 199
Error due to multiple causes.
Cheers
katty
2012/12/19 Mark Wagner <[email protected]
<mailto:[email protected]>>
Hi Kathy,
I think the design you opened up was built with an older version
of the libraries. All you need to do is open up the simulink
browser and pull that fft into your design, then open up the
paramter boxes of both and make sure that the parameters are the
same. After that, delete the old one and replace it with the new.
Mark
On Wed, Dec 19, 2012 at 5:14 PM, katherine viviana cortes urbina
<[email protected] <mailto:[email protected]>> wrote:
Hi mark,
Where I get of newer versions of fft and pfb_fir?
Cheers
Katty
El 19/12/2012 19:10, "katherine viviana cortes urbina"
<[email protected] <mailto:[email protected]>>
escribió:
Hi mark,
Where I try of newer versions of fft and pfb_fir ?
Cheers
El 19/12/2012 18:52, "Mark Wagner"
<[email protected]
<mailto:[email protected]>> escribió:
Hi Katty,
I think it's possible you're using older versions of
the fft and the pfb_fir. Could you try to replacing
those with the ones from the library you have open
(with the same parameter settings)? And then try ctrl-d?
Mark
On Wed, Dec 19, 2012 at 4:32 PM, katherine viviana
cortes urbina <[email protected]
<mailto:[email protected]>> wrote:
Dear Casperites,
I am design a Spectrometer of 1Ghz, I just be
parameters in the existing blocks. I change the
parameter 'Number of simultaneous inputs' set to
3. But when I compile design , I have the error:
#############################
## System Update ##
#############################
Error using ==> gen_xps_files at 199
Error due to multiple causes.
if I do ctrl + d , I see the attachments.
Cheers
Katty
