Hi Jack, The error message I am still having is "Error using gen_xps_files (line 189) Error in 'tut3/fft_wideband_real': Initialization commands cannot be evaluated. Simulink:Commands:ParamUnknown: fft_unscrambler block (mask) does not have a parameter named 'coeffs_bit_limit' after I have updated the blocks. It seems that there is no such parameter there in the model file. Thanks!
Bodow On 11/10/13, Jack Hickish <[email protected]> wrote: > Hi Bodow, > > Are you using the Casper libraries linked at the top of the tutorials wiki > page? If not, you may find that some blocks in the tutorial are out of date > compared to the library you are using. > > The simplest way to fix this is to replace the offending block in the model > (the error message should tell you which block this is) with a fresh copy > from the library. You'll need to make sure you configure the new block with > the same parameters as the old one. > > You can automate this process with Dave MacMahon's > 'update_casper_block(<block name>)' matlab script, which i believe is > present in most of the major Casper library git repositories. There is also > a script 'update_casper_blocks(<model name>)' which will update all the > Casper blocks in the model, but be warned that this can take some time. > > Hope this helps, > > Jack > On 10 Nov 2013 04:36, "anson" <[email protected]> wrote: > >> Dear all, >> >> I've tried to compile .mdl tutorial 3 under the Ubuntu 12.04 64-bit, >> Matlab 2012b and Xilinx 14.5, using the configuration in: >> >> https://casper.berkeley.edu/wiki/MSSGE_Setup_with_Xilinx_14.5_and_Matlab_2012b >> It returns with an initializing error. >> However, when I compiled the tutorial 1, everything was fine. >> Any thoughts with that? Thank you. >> >> Bodow >> >> > -- Best Regards, Anson Tang, M.Phil. candidate, Applied Life Photonics, Department of Electrical & Electronic Engineering, The University of Hong Kong
