Marc, Here is an update on the issue:
Sometimes when I issue a reset of the one_GbE yellow block, the V6 port will get into a mode where it does send data out of the port. I have a few telemetry points connected to the front panel, so I know that when it is in this state, the following is true: 1) tx_afull = 0 2) tx_overrun = 0 3) rx_val = 0 4) rx_eof = 0 5) rx_overrun = 0 7) tx_val is toggling hire regularly indicating that data is being fed to the interface 8) tx_eof = ?? (probably toggle high, but I do not latch the value and the duty cycle is too low to see on the LED). also rx_srcip = 0 and rx_srcport = 0. When data is being sent to the port, data is seen by the WireShark program, but only the beginning of the packet is received. Any ideas on what to do next? -Joe Kujawski
