*From: *"[email protected]" <[email protected]>
*Subject: **Re: [casper] 2 simul. Input FFT library and ADC16x250-8*
*Date: *April 23, 2016 at 10:40:32 AM EDT
*To: *indrajit <[email protected]>
*Cc: *[email protected]


Hi, Indrajit,

I can answer question 2.  ADC16 is not (yet?) supported on ROACH1.  The
card and the associated "yellow block" and HDL was developed for use with
ROACH2 and nobody has had the need/desire to port that over to work on
ROACH1.  It would be a non-trivial but rewarding (IMHO) effort for someone
who wanted to dive into the internals of the CASPER toolflow.

Hope this helps,
Dave

On Apr 22, 2016, at 10:38 PM, indrajit <[email protected]> wrote:

Hello all,


Question #1 :

I am looking for a suitable CASPER library for 2 simultaneous input FFT
library. (see bellow link)

https://app.box.com/s/jqx5mp9dqkgyf5hijd3ztyjtspydktqq

How to use simple FFT biplex to implement the same.


Question #2:

Is there anyone used this ADC16x250-8_coax_rev_2  card with ROACH 1 .

https://casper.berkeley.edu/wiki/ADC16x250-8_coax_rev_2

The document says:

   - *Roach1*
   - The Virtex 5 FPGA, as used on the Roach1, has an LVDS interface to the
   ZDok+ connector pins that might not be able to run at speeds required to
   accept the ADC ICs' outputs at full rate. In practice we may need to limit
   the maximum speed to be 800 Mbps or so. We will push the maximum speed as
   high as possible but at some point we might need to cut our losses and move
   on.
   - When using this 16 input ADC card with a Roach1 the 3 operating modes
   MAY be restricted to something like :
      - 16 inputs by 200 MSPS by 8 bits
         - actual clock rates are : TBD
      - 8 inputs by 400 MSPS by 8 bits
         - actual clock rates are : TBD
      - 4 inputs by 800 MSPS by 8 bits
         - actual clock rates are : TBD
      - Actual maximum clock rates will only be found during the Yellow
      Block development and lab testing.
      - See the Roach2 section above - there may be some strange sample
      clock rate rules for the Roach1 too

   Looking for your comments is there any improvement, Do's and Dont's .

Looking for your answers

Thanks

Indrajit

Reply via email to