I personally recomend to take capture of all the configs of the switches and routers and save them in individual files... because if you mess with some pre-existng configuration, then you would have a backup what was earlier configured...
apart from that while reading through the lab at the begining, check what kind of firewalls you are getting, Routed/transparent/Multicontex/Multicontext-FO. .. in either case make sure that you start with your FW's mode changed, because a reload takes more than 90 seconds on each firewall,,, you can continue reading the lab in the mean time. Regards, FNK On Wed, Dec 21, 2011 at 5:17 PM, Mark Senteza <[email protected]>wrote: > Kings, > > All you listed is good. I'd add "show run | in access-list" too to that > list > > All the best > > Mark > CCIE #30234 (Security) > > On 12/21/11, Andrey Klyuchka <[email protected]> wrote: > > Kings, > > > > I would have done only part with sh access-list like Piotr noted and also > > copied configs to the desktop. > > In the finish I would coded script in notepad with things like this: > > > > no debug all > > no logging con > > etc > > > > That's all, I actually did so. 2 times ) > > Good luck! > > > > Best regards, > > Andrey > > > > -- > > Andrey Klyuchka :: CCIE #30274 (Security) > > Twitter: http://twitter.com/bitstriker > > LinkedIn: http://kz.linkedin.com/in/andreyklyuchka > > > > > > > > On Dec 21, 2011, at 11:27 AM, Kingsley Charles wrote: > > > >> Hi all > >> > >> I will be performing the following checks before starting my lab that > >> would be helpful for troubleshooting: > >> > >> Router > >> > >> sh run | in ip access-group > >> sh run | in ip local > >> sh run | in ip policy > >> sh run | in service-policy > >> > >> Switch > >> > >> sh run | in ip access-group > >> sh run | in vlan filter > >> > >> > >> Please provide your comments. > >> > >> > >> With regards > >> Kings > >> _______________________________________________ > >> For more information regarding industry leading CCIE Lab training, > please > >> visit www.ipexpert.com > >> > >> Are you a CCNP or CCIE and looking for a job? Check out > >> www.PlatinumPlacement.com > > > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
