For backing up the running configuration, why can't we copy the running config to the router's/switch's flash itself. It will be quicker.
With regards Kings On Fri, Dec 23, 2011 at 7:26 AM, Fawad Khan <[email protected]> wrote: > I personally recomend to take capture of all the configs of the switches > and routers and save them in individual files... because if you mess with > some pre-existng configuration, then you would have a backup what was > earlier configured... > > apart from that while reading through the lab at the begining, check what > kind of firewalls you are getting, > Routed/transparent/Multicontex/Multicontext-FO. .. in either case make > sure that you start with your FW's mode changed, because a reload takes > more than 90 seconds on each firewall,,, you can continue reading the lab > in the mean time. > > > Regards, > FNK > > > On Wed, Dec 21, 2011 at 5:17 PM, Mark Senteza <[email protected]>wrote: > >> Kings, >> >> All you listed is good. I'd add "show run | in access-list" too to that >> list >> >> All the best >> >> Mark >> CCIE #30234 (Security) >> >> On 12/21/11, Andrey Klyuchka <[email protected]> wrote: >> > Kings, >> > >> > I would have done only part with sh access-list like Piotr noted and >> also >> > copied configs to the desktop. >> > In the finish I would coded script in notepad with things like this: >> > >> > no debug all >> > no logging con >> > etc >> > >> > That's all, I actually did so. 2 times ) >> > Good luck! >> > >> > Best regards, >> > Andrey >> > >> > -- >> > Andrey Klyuchka :: CCIE #30274 (Security) >> > Twitter: http://twitter.com/bitstriker >> > LinkedIn: http://kz.linkedin.com/in/andreyklyuchka >> > >> > >> > >> > On Dec 21, 2011, at 11:27 AM, Kingsley Charles wrote: >> > >> >> Hi all >> >> >> >> I will be performing the following checks before starting my lab that >> >> would be helpful for troubleshooting: >> >> >> >> Router >> >> >> >> sh run | in ip access-group >> >> sh run | in ip local >> >> sh run | in ip policy >> >> sh run | in service-policy >> >> >> >> Switch >> >> >> >> sh run | in ip access-group >> >> sh run | in vlan filter >> >> >> >> >> >> Please provide your comments. >> >> >> >> >> >> With regards >> >> Kings >> >> _______________________________________________ >> >> For more information regarding industry leading CCIE Lab training, >> please >> >> visit www.ipexpert.com >> >> >> >> Are you a CCNP or CCIE and looking for a job? Check out >> >> www.PlatinumPlacement.com >> > >> > >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> Are you a CCNP or CCIE and looking for a job? Check out >> www.PlatinumPlacement.com >> > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
