Ok but if the gateway end is the Call Manager Sub how do you set it? Linda
From: Tech Guy [mailto:tech...@oletu.com] Sent: Tuesday, April 07, 2009 8:38 AM To: Linda Mordosky (lmordosk); ccie_voice@onlinestudylist.com Subject: Re: [OSL | CCIE_Voice] Gatekeeper config You set the resource threshold at the gateway end: ! gateway resource threshold high 70 low 60 ! Tech Guy ----- Original Message ----- From: Linda Mordosky (lmordosk) <mailto:lmord...@cisco.com> To: ccie_voice@onlinestudylist.com Sent: Tuesday, April 07, 2009 7:45 AM Subject: [OSL | CCIE_Voice] Gatekeeper config Has anyone been successful in using the gatekeeper endpoint id max-calls h323- command? I need to configure the gatekeeper with only three endpoints, one local zone and only allow one call to use the CCM_2 (subscriber trunk) at a time. Here is my gatekeeper config so far gatekeeper zone local GK cisco.com 10.87.80.43 no zone subnet GK default enable zone subnet GK 10.87.80.45/32 enable zone subnet GK 10.87.93.123/32 enable zone subnet GK 10.87.93.122/32 enable zone prefix GK 2* gw-priority 9 CCM_2 zone prefix GK 2* gw-priority 0 CME zone prefix GK 3* gw-priority 10 CCM_2 zone prefix GK 3* gw-priority 9 CCM_1 zone prefix GK 3* gw-priority 0 CME zone prefix GK 4* gw-priority 10 CME zone prefix GK 4* gw-priority 0 CCM_2 CCM_1 no shutdown I am trying to set the resource threshold and can't figure out how to set the High and Low marks for the CCM trunk? The goal is to only allow one call to CCM_2 at a time. So a call would only use CCM_1 if and only if there was an active call on CCM_2. Any ideas? Linda