That won't work because you have two trunks in Call Manager and you only
want to limit the bw to one trunk not both.  So the CCM_2 can only
handle one call but CCM_1 can handle multiple calls

Linda

 

From: Tech Guy [mailto:[email protected]] 
Sent: Tuesday, April 07, 2009 8:49 AM
To: Tech Guy; Linda Mordosky (lmordosk); [email protected]
Subject: Re: [OSL | CCIE_Voice] Gatekeeper config

 

If gateway is CallManager, define a new location and allocate enough
bandwidth for one g729 call to this gatekeeper trunk. 


Tech Guy

 

 

        ----- Original Message ----- 

        From: Tech Guy <mailto:[email protected]>  

        To: Linda Mordosky (lmordosk) <mailto:[email protected]>  ;
[email protected] 

        Sent: Tuesday, April 07, 2009 8:38 AM

        Subject: Re: [OSL | CCIE_Voice] Gatekeeper config

         

        You set the resource threshold at the gateway end:

         

        !         
        gateway 
         resource threshold high 70 low 60 
        !

         

        
        Tech Guy

         

                ----- Original Message ----- 

                From: Linda Mordosky (lmordosk)
<mailto:[email protected]>  

                To: [email protected] 

                Sent: Tuesday, April 07, 2009 7:45 AM

                Subject: [OSL | CCIE_Voice] Gatekeeper config

                 

                Has anyone been successful in using the  gatekeeper
endpoint id max-calls h323- command? 

                 

                 I need to configure the gatekeeper with only three
endpoints, one local zone and only allow one call to use the CCM_2
(subscriber trunk) at a time.   Here is my gatekeeper config so far

                 

                gatekeeper

                 zone local GK cisco.com 10.87.80.43

                 no zone subnet GK default enable

                 zone subnet GK 10.87.80.45/32 enable

                 zone subnet GK 10.87.93.123/32 enable

                 zone subnet GK 10.87.93.122/32 enable

                 zone prefix GK 2* gw-priority 9 CCM_2

                 zone prefix GK 2* gw-priority 0 CME

                 zone prefix GK 3* gw-priority 10 CCM_2

                 zone prefix GK 3* gw-priority 9 CCM_1

                 zone prefix GK 3* gw-priority 0 CME

                 zone prefix GK 4* gw-priority 10 CME

                 zone prefix GK 4* gw-priority 0 CCM_2 CCM_1

                 no shutdown

                 

                I am trying to set the resource threshold and can't
figure out how to set the High and Low marks for the CCM trunk?  The
goal is to only allow one call to CCM_2 at a time.  So a call would only
use CCM_1 if and only if there was an active call on CCM_2.  

                 

                Any ideas?

                Linda

Reply via email to