When I use the arq reject-resoure-low command the second call is rejected by the Gatekeeper but does not go to the CCM_1 trunk the call re-routes to the PSTN as a second choice of the route list.
Linda From: Vik Malhi [mailto:[email protected]] Sent: Tuesday, April 07, 2009 9:22 AM To: Linda Mordosky (lmordosk); OSL Group Subject: Re: [OSL | CCIE_Voice] Gatekeeper config I think you need to use the following config to specify that a specific h323id can only carry a maximum of one active call: Gatekeeper ... endpoint max-call h323id trunk_1 endpoint resource-threshold arj reject-resource-low http://www.cisco.com/en/US/docs/ios/12_3/vvf_r/vrg_e1.html#wp1018031 -- Vik Malhi - CCIE #13890, CCSI #31584 Senior Technical Instructor - IPexpert, Inc. Telephone: +1.810.326.1444 Fax: +1.810.454.0130 Mailto: [email protected] Join our free online support and peer group communities: http://www.IPexpert.com/communities IPexpert - The Global Leader in Self-Study, Classroom-Based, Video-On-Demand and Audio Certification Training Tools for the Cisco CCIE R&S Lab, CCIE Security Lab, CCIE Service Provider Lab , CCIE Voice Lab and CCIE Storage Lab Certifications. ________________________________ From: "Linda Mordosky (lmordosk)" <[email protected]> Date: Tue, 7 Apr 2009 07:46:41 -0400 To: "Linda Mordosky (lmordosk)" <[email protected]>, OSL Group <[email protected]> Subject: Re: [OSL | CCIE_Voice] Gatekeeper config Forgot to add the link which explains the resource threshold commands http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a00800 93f67.shtml From: Linda Mordosky (lmordosk) Sent: Tuesday, April 07, 2009 7:46 AM To: '[email protected]' Subject: Gatekeeper config Has anyone been successful in using the gatekeeper endpoint id max-calls h323- command? I need to configure the gatekeeper with only three endpoints, one local zone and only allow one call to use the CCM_2 (subscriber trunk) at a time. Here is my gatekeeper config so far gatekeeper zone local GK cisco.com 10.87.80.43 no zone subnet GK default enable zone subnet GK 10.87.80.45/32 enable zone subnet GK 10.87.93.123/32 enable zone subnet GK 10.87.93.122/32 enable zone prefix GK 2* gw-priority 9 CCM_2 zone prefix GK 2* gw-priority 0 CME zone prefix GK 3* gw-priority 10 CCM_2 zone prefix GK 3* gw-priority 9 CCM_1 zone prefix GK 3* gw-priority 0 CME zone prefix GK 4* gw-priority 10 CME zone prefix GK 4* gw-priority 0 CCM_2 CCM_1 no shutdown I am trying to set the resource threshold and can't figure out how to set the High and Low marks for the CCM trunk? The goal is to only allow one call to CCM_2 at a time. So a call would only use CCM_1 if and only if there was an active call on CCM_2. Any ideas? Linda
