thanks for discuss. anyone can give me some confirm?
------------------ Original ------------------
From: "Rogers Ochieng"<[email protected]>;
Date: Wed, Jan 19, 2011 09:26 PM
To: "Shrini"<[email protected]>;
Cc: "Roger Kllber"<[email protected]>;
"bruno"<[email protected]>; "ccie_voice"<[email protected]>;
Subject: Re: [OSL | CCIE_Voice] why trunk mode on ESW?
All recommendations i see prefers the new way, even though out of our scope
it's more secure as compared to trunk mode.
On 19 January 2011 14:12, Shrini <[email protected]> wrote:
Hi Roger,
I agree with "legacy" word, but I prefer trunk for our purpose, reason is
below link.
access mode and trunk mode both explained well here.
http://www.cisco.com/en/US/docs/ios/lanswitch/configuration/guide/lsw_hwic_ethsw_ic_ps6441_TSD_Products_Configuration_Guide_Chapter.html#wp1049866
-S
From: [email protected]
[mailto:[email protected]] On Behalf Of Roger Kllberg
Sent: Wednesday, January 19, 2011 2:13 AM
To: bruno; ccie_voice
Subject: Re: [OSL | CCIE_Voice] why trunk mode on ESW?
Hi Bruno,
First of all I do not speak for IPX, but my understanding is that the reason
for why the vol1 has the old way of configuring the ports on ESW module is
because of at the time of when it was written this was the way these ports were
configured.
I can from my own experience say that you definitely can configure these ports
with the access port mode. This is what I did after I realized that this was
now supported. But it might be good to practise on both methods, you never know
if you will get that as a requirement in the lab.
Sincerely
Roger Kllberg
CCIE #26199 (Voice)
Consultant
Cygate AB
Eric Perssons vg 21, SE-217 62 MALM
Frn: bruno [[email protected]]
Skickat: den 19 januari 2011 07:18
Till: ccie_voice
mne: [OSL | CCIE_Voice] why trunk mode on ESW?
Dear all
in vol1 network infrastrure,
why we need to configure trunk mode on esw,why not access mode .i have test
the access mode is ok.
SITEB(config)#int range f0/1/0 -3
SITEB(config-if-range)# switchport trunk native vlan 602
SITEB(config-if-range)# switchport mode trunk
SITEB(config-if-range)# switchport voice vlan 502
SITEB(config-if-range)#description ***CONNECT TO IP PHONE***
SITEC#show interfaces f0/1/0 switchport
Name: Fa0/1/0
Switchport: Enabled
Administrative Mode: trunk
Operational Mode: trunk
Administrative Trunking Encapsulation: dot1q
Operational Trunking Encapsulation: dot1q
Negotiation of Trunking: Disabled
Access Mode VLAN: 0 ((Inactive))
Trunking Native Mode VLAN: 602 (DATA-VLAN)
Trunking VLANs Enabled: ALL
Trunking VLANs Active: 1,502,602
Protected: false
Priority for untagged frames: 0
Override vlan tag priority: FALSE
Voice VLAN: 502
Appliance trust: none
Best Regards,
bruno
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
