Hi Adam, Below config is working. But if I add button 3:2 under ephone 1, then it is turning red even if I press line 3 (shared line) on ephone 1. In call manager it is not like this. ephone-dn 1 oct number 1000 no-reg name Line1 Phn1
ephone-dn 2 oct number 1001 no-reg name Line2 Phn1 ephone-dn 3 oct number 1002 no-reg name Line1 Phn2 ephone 1 mac 1111.2222.3333 button 1:1 2:2 ... ephone 2 mac 4444.5555.6666 button 1:3 2w1 3:2 ---> To my understanding w will watch the entire phone. I am using CME7.0 and as per this doc <http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/gui de/cmepres.html#wp1022428> http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guid e/cmepres.html#wp1022428 blf will monitor single line and dnd with CME 7.1, I will try upgrading. Thanks Shrini _____ From: [email protected] [mailto:[email protected]] On Behalf Of Adam Thompson Sent: Friday, January 21, 2011 1:47 PM To: [email protected] Subject: Re: [OSL | CCIE_Voice] BLF in CME Shrini, You will want to setup your CME configuration something like this: ephone-dn 1 oct number 1000 no-reg name Line1 Phn1 ephone-dn 2 oct number 1001 no-reg name Line2 Phn1 ephone-dn 3 oct number 1002 no-reg name Line1 Phn2 ephone 1 mac 1111.2222.3333 button 1:1 2:2 ... ephone 2 mac 4444.5555.6666 button 1:3 2w1 ... This will allow you to watch Phone 1 Line 1 using your button2 on Phone 2. You will get idle/off-hook/DnD for only this line. HTH -Adam On Fri, Jan 21, 2011 at 2:50 PM, Shrini <[email protected]> wrote: Hi Team, I configured BLF on CUCM and I wanted to get it worked in the same way in CME too. Scenario: I have two lines on the phone. In CUCM when I configure BLF for Line 1 and it works as expected. BLF flickers for incoming call , turn red in active call / off hook / DnD. But on CME. There are two options : blf or watch If I do blf it only lits red when active / off hook not with DnD. If I do watch phone it lits in all conditions as mentioned above in CUCM excepts incoming call but It watched line 2 also. How can I configure same exacltly like it is working on CUCM. http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guid e/cmepres.html#wp1022428 In the above documentation it is mentioned that BLF does not work for DnD in CME 7.0 Please advice T I A Shrini _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
