Some big Fujitsu SPARC machines, too, if anyone's into those ... some old-ish looking HP boards of unclear provenance (probably came out of test equipment) ... Nice Ungar soldering station in good shape ... very cheap Cisco Sup720s ... a Shugart 801 ... interesting assortment of stuff ... prices are kind of here and there ...
I looked at the dual DEC floppy and I'm not seeing how it would fit in a BA23; the BA23 uses a little plastic sled attaching to the bottom of whatever goes in the 5.25" bay; it latches onto a catch at the bottom of the bay; this seems to mount to something with a sort of rail and retaining thumbscrew arrangement? Best, Sean On Sun, Aug 9, 2015 at 6:58 PM, Sean Caron <[email protected]> wrote: > Grumble ... Google mail ... > > > http://www.ebay.com/itm/Texas-Instruments-Silent-700-Data-Terminal-T367-/181827278594?hash=item2a55c01702 > > Best, > > Sean > > > On Sun, Aug 9, 2015 at 6:58 PM, Sean Caron <[email protected]> wrote: > >> He's got a lot of interesting stuff for sale ... anyone looking for a >> Silent 700? >> >> >> On Sun, Aug 9, 2015 at 6:49 PM, Ben Sinclair <[email protected]> wrote: >> >>> If it was a salvageable set of RX02s, it would have been nice to have! >>> Too bad he pulled the listing. >>> >>> On Sun, Aug 9, 2015 at 5:06 PM, Pete Turnbull <[email protected]> >>> wrote: >>> > On 09/08/2015 18:14, Sean Caron wrote: >>> >> >>> >> DEC did sell a version of the BA23 that was intended to be used just >>> as an >>> >> expansion peripherals cabinet. You shouldn't have any problems >>> putting HH >>> >> devices in BA23 bays (so long as you have the appropriate interfaces >>> to >>> >> drive them) but you may need i.e. 3.5" to 5.25" bracket to attach to >>> the >>> >> BA23 sleds, and you'll have (cosmetic) blank space on top after >>> putting a >>> >> HH device in a FH bay. I imagine you'd have to make a special bracket >>> to >>> >> mount a TZ30/RX33 over-under in one of the 5.25" bays in the BA23 but >>> it >>> >> could certainly be done ... No such factory configuration exists AFAIK >>> > >>> > >>> > If a TZ30 has the same mounting holes as a 5.25" disk drive, it's >>> doable. >>> > There's an official DEC mounting kit to mount 2 x RX33 where you'd >>> normally >>> > find an RX50 in a BA23/BA123. It's basically two side plates, to hold >>> the >>> > upper and lower drives together. >>> > >>> > -- >>> > Pete >>> > >>> > Pete Turnbull >>> >>> >>> >>> -- >>> Ben Sinclair >>> [email protected] >>> >> >> >
