On 09/08/2015 23:21, Sean Caron wrote:
I did not know that. It must have been a fairly rare thing? I don't think
I've ever seen one photographed.
I didn't think it was /that/ rare. I believe should have one here
somewhere, so if I can find one I'll photograph it.
On Sun, Aug 9, 2015 at 6:06 PM, Pete Turnbull <p...@dunnington.plus.com>
wrote:
On 09/08/2015 18:14, Sean Caron wrote:
DEC did sell a version of the BA23 that was intended to be used just as an
expansion peripherals cabinet. You shouldn't have any problems putting HH
devices in BA23 bays (so long as you have the appropriate interfaces to
drive them) but you may need i.e. 3.5" to 5.25" bracket to attach to the
BA23 sleds, and you'll have (cosmetic) blank space on top after putting a
HH device in a FH bay. I imagine you'd have to make a special bracket to
mount a TZ30/RX33 over-under in one of the 5.25" bays in the BA23 but it
could certainly be done ... No such factory configuration exists AFAIK
If a TZ30 has the same mounting holes as a 5.25" disk drive, it's doable.
There's an official DEC mounting kit to mount 2 x RX33 where you'd normally
find an RX50 in a BA23/BA123. It's basically two side plates, to hold the
upper and lower drives together.
--
Pete
Pete Turnbull
--
Pete
Pete Turnbull
