Movin right along.
Programmers console now properly attached to light screening bar.
Front panel and bezel on. Needs a bit more work.
Not as secure or as straight as I would like.
Then there's the key lock problem.
Its in the off position and of course I don't have the key.
So I cant fit that just now.
Took power supply out. Changed mains cable as it was only a foot long.
Soldered to the circuit breaker was a factory standard would you believe.
Power supply back in. Connect up. Power on. Load address 0000, press
CLEAR and CONT.
Test program still in core. Started right up.
To-days task get the serial I/O going.
Rod in Restore Mode
Wanted one pdp-8/i rocker switch leaver to copy.