Speaking from experience from having done a few Unibus boards now (none of them 
available yet unfortunately) that providing a general Unibus interface on a 
quad board will consume a reasonable amount of the board space and limit 
flexibility on which driver/receiver/transceiver parts that can be used.  
That’s just for the Unibus drivers.  If you want to actually *run* the 
interface then you’re talking a lot more stuff.

Of course, the boards I’m doing are all SMD (with the exception of the unibus 
interface parts).  I also have to add in 5v to 3.3v conversion.  Even on a 4 
layer board there’s lots of “congestion” which limits the number of parts that 
can actually placed on the board.  :-(

TTFN - Guy

> On Aug 15, 2019, at 1:23 AM, emanuel stiebler via cctalk 
> <cctalk@classiccmp.org> wrote:
> On 2019-08-15 02:13, systems_glitch via cctalk wrote:
>> Connor Krukosky and I have been working on laying out a new quad-height DEC
>> protoboard, which can also be sheared down into a dual-height board. Full
>> announce on the VC Forums:
>> http://www.vcfed.org/forum/showthread.php?71177-GW-DEC-1-A-New-Quad-Height-DEC-Prototyping-Board&p=582892#post582892
> Was always hoping somebody would do something like that, but with the
> bus interface already on it ...

Reply via email to