Paul, I've got a board house I usually use, but if I can find a shop in the USA that will do hard gold plating and provide a comparable cost-per-board, I'd certainly switch!
Thanks, Jonathan On Fri, Aug 16, 2019 at 12:55 AM Paul Anderson <used...@gmail.com> wrote: > Hi Jonathan, > > If you are looking for someone to make the boards, I know someone in CA. > I'll try to dig up his contact info this weekend. > > Paul > > > On Wed, Aug 14, 2019 at 7:14 PM systems_glitch via cctalk < > email@example.com> wrote: > >> Connor Krukosky and I have been working on laying out a new quad-height >> DEC >> protoboard, which can also be sheared down into a dual-height board. Full >> announce on the VC Forums: >> >> >> http://www.vcfed.org/forum/showthread.php?71177-GW-DEC-1-A-New-Quad-Height-DEC-Prototyping-Board&p=582892#post582892 >> >> These should be available within a month or so. I'll be putting up a >> preorder soon to gauge interest in the production run, which as usual will >> have hard gold plating on the edge connectors. I haven't gotten a quote >> for >> the cost, but I expect them to be $30-40 each for production boards. >> They'll be available at VCF Midwest as well as online! >> >> Thanks, >> Jonathan >> >