Well, almost all names work. But fit does not. 1 2(,:!.10)3 4 5
1 2 10 3 4 5 1 2(laminate fit 10)3 4 5 |domain error: fit | 1 2(laminate fit 10)3 4 5 Also, for CamelCase, comment out line 253 in primitives.ijs . On Sun, Mar 4, 2018 at 12:58 PM, Brian Schott <[email protected]> wrote: > Ian, > > I like your ideas regarding general/primitives . I just did a load of the > addon and was surprised that they are lowercase. My memory suggested they > were uppercase initial letters like the Vocabulary. But I never use them, > so take what I say with that in mind. I was please to see that in jqt an F1 > tap when the cursor is near the primitive, or near the spelled-out > primitive, took me to the Vocabulary page. I was expecting to be delivered > to the Dictionary page, though. Maybe that's something I have not > configured properly on my Mac. Another disappointment on my Mac was that > shift+F1 did not take me to NuVoc (again, maybe a config issue). > > And, all of F1 access leaves out jconsole and jhs as far as I can tell. So, > I suspect new users are steered to jqt. > > I personally lean toward jconsole in much of my J use, btw. > > JVERSION > Engine: j806/j64/darwin > Release: commercial/2017-11-06T10:20:33 > Library: 8.06.09 > Qt IDE: 1.6.2/5.6.3 > Platform: Darwin 64 > Installer: J806 install > InstallPath: /users/brian/j64-806 > Contact: www.jsoftware.com > ---------------------------------------------------------------------- > For information about J forums see http://www.jsoftware.com/forums.htm > ---------------------------------------------------------------------- For information about J forums see http://www.jsoftware.com/forums.htm
