Re: [Chevelle-List] trans

[yenkochevelle]

The TH400 front yoke was also used on some of the later 4sp trans drive shafts. Like the M22 trans in 1970. ----- Original Message ----- From: [EMAIL PROTECTED] To: [EMAIL PROTECTED] Sent: Thursday, February 20, 2003 10:34 PM Subject: Re: [Chevelle-List] trans You will need to have your driveshaft shortened and use what is called a "junk joint" for using a TH400 yoke on a TH350 driveshaft.  The yokes are specific to TH400 tannys. TH350 uses a cable kickdown whereas a TH400 uses an electric one.  You don't really need to have the kickdown installed on a TH400, manual kickdown works just fine :-).  I have a TH400 in my 70 and have never had the kickdown hooked up, I just manually drop it in 2nd when I need to pass someone.  Your crossmember is the same, just have to relocate it back 4 inches, there are holes pre-drilled in the frame.  I don't think I am missing anything else here, but if I am, someone else will chime in. Tom