Hey Brad, If your interested, I would like you to run some numbers on a my wicked 540... Thanks joe
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Brad Waller Sent: Friday, June 29, 2007 12:54 PM To: 'The Chevelle Mailing List' Subject: Re: [Chevelle-list] Copy your 402? Pelle, Which heads do you have? I can run a Dyno2000 simulation with your setup and get some guesses. Give me a "parts list" of the engine builds you are thinking of. If you have Cam specs or the actual cam name I might have them stored already. I took some guesses as to components and came up with a 425 HP combo off the bat. I used what you gave me and assumed Edelbrock Performer heads and a high performance hydraulic lifter cam. The program assumed lifts of .504/.479 and the engine is guessed to have 424HP at 5500 RPM, but torque starts at 411 at 2000 RPM, peaks at 450 at 4000 RPM, and drops to 366 by 6000 RPM. Not an actual engine to copy, but at least it gives you an idea what you can look into. The only 402 file I have is from an engine with a roller cam. It has GM Rectangular port "188" heads, a 850 CFM carb with a dual plane intake, small tube headers, and Comp XR282HR cam. Numbers are: RPM HP TQ 2000 168 442 2500 218 457 3000 268 469 3500 322 484 4000 371 487 4500 413 481 5000 436 458 5500 432 412 6000 410 359 Brad Waller ([EMAIL PROTECTED]) '66 Corvette | 327/dead | 4-speed | Wilwood Brakes | 245/45/16 BFG R1 '67 Chevelle | ex-SS396 | 355/700R4 | F-Body Brakes | 275/40/17 Kumho MX ________________________________ From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Pelle Andersson Sent: Friday, June 29, 2007 8:35 AM To: The Chevelle Mailing List Subject: [Chevelle-list] Copy your 402? Does anyone have a 402 (.060 over) 2-bolt main with approx 400-500 hp which i can copy? I'm asking because when i get my block back from the machine shop I'd like to get "bolt on" hp without too much hassle/experimentation. Im planning to raise the comp to 10:1(new pistons), keep the original heads, my 800 cfm Holley, my Hooker headers with 2'' primarys and my Edelbrock RPM performance Intake. I know i've been pestering you guys with this before but I still need some ideas/input/advice! Best regards Pelle ______________________________ Chevelle gearheads http://hem.bredband.net/chevellegearheads/ http://www.chevelleforum.se/
