Thank you for your response. i do select the serial port (com port).
I will I’ll have to research as I have never selected a USB port. I just plug it in to the USB on the computer thanks again...stay safe and stay healthy joe > On September 7, 2020 2:39 PM D.J.J. Ring, Jr. <[email protected]> wrote: > > > You have to select the USB port that your radio is connected to. > > 73 > > DR > > On Mon, Sep 7, 2020 at 5:28 PM joe < [email protected] > mailto:[email protected] > wrote: > > > > Hi everyone, > > > > Windows 10 computer > > > > I am trying to clone the Yaesu FT8900R (this is the first time) > > > > I use CHIRP and I follow the CHIRP instructions (same as in Yaesu > > manual) > > > > I turn on the radio, go to F6 "clone start", then push "set" > > > > Nothing happens...after a few seconds, I get error message stating > > it could not find the item location (com port). Tried several times on all > > four active ports. > > > > Checked "device manager" and the four ports are active and well > > > > Any help or suggestions will be greatly appreciated > > > > Joe > > _______________________________________________ > > chirp_users mailing list > > [email protected] > > mailto:[email protected] > > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > > This message was sent to D.J.J. Ring, Jr. at [email protected] > > mailto:[email protected] > > To unsubscribe, send an email to > > [email protected] > > mailto:[email protected] > > > > > _______________________________________________ > chirp_users mailing list > [email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to joe Shapley at [email protected] > To unsubscribe, send an email to > [email protected] >
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
