No responses so far? Jose
The Father wrote: > Hi everyone. I'm trying to find a way to rate-limit or police to 3Mbps > two of the switch ports on an 1811 router. I have configured both FE > ports as follows: > > interface FastEthernet2 > switchport access vlan 10 > load-interval 30 > ! > interface FastEthernet9 > switchport access vlan 10 > load-interval 30 > > Now since these are basically layer 2 ports, I can't come up with a > policy map or ACL to police them down to the 3Mbps value I want. > Everything I try does not get matched. The router doesn't seem to > support aggregate policing either so I'm kinda stuck. Are there any > other options that would work? > > FYI, I'm running 12.4(6)T7 Advanced IP Services code. > > Thanks. > > Jose > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
