I've done ratelimiting on similar kit but on the l3 ports, ie: int fa2 switchport access vlan 2 ! int fa3 switchport access vlan 3 ! int vlan 3 ip addr x.x.x.x y.y.y.y <insert generic rate limiting here> !
Rate limiting on the SVI will work fine if all ports on that vlan are going to be ratelimited. If not, you could possibly try multiple SVIs bridged together with a BVI and do the shaping on the relevant SVIs. No idea if that'll work and I don't have an 18xx handy to test that.. Adrian On Thu, Jun 07, 2007, The Father wrote: > Hi everyone. I'm trying to find a way to rate-limit or police to 3Mbps > two of the switch ports on an 1811 router. I have configured both FE > ports as follows: > > interface FastEthernet2 > switchport access vlan 10 > load-interval 30 > ! > interface FastEthernet9 > switchport access vlan 10 > load-interval 30 > > Now since these are basically layer 2 ports, I can't come up with a > policy map or ACL to police them down to the 3Mbps value I want. > Everything I try does not get matched. The router doesn't seem to > support aggregate policing either so I'm kinda stuck. Are there any > other options that would work? > > FYI, I'm running 12.4(6)T7 Advanced IP Services code. > > Thanks. > > Jose > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ -- - Xenion - http://www.xenion.com.au/ - VPS Hosting - Commercial Squid Support - - $25/pm entry-level bandwidth-capped VPSes available in WA - _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
