Hi Omar, verify the source address of your packets. Your configuration is correct. Is possible that your packets didn't have a source address from 172.20.0.48/30 subnet.
Try change the 'match ip address 160' by the following command: 'match interface FastEthernet0/0.73' This will match all packets coming from interface FastEthernet0/0.73. Another way is to rebuild your ACL 160 with the correct source address of your packets. Regards, Diogo On 7/2/07, omar parihuana <[EMAIL PROTECTED]> wrote: > Hi List, > > I've configured an policy routing, however the packets don't match the > policy. I re-checked the configuration and all seems fine, I don't know why > that configuration don't work!!! (the packets traverse by default route and > not by Next-hop configured into route-map. > > I've paste my configuration: > > ! > interface FastEthernet0/0.73 > encapsulation dot1Q 73 > ip address 172.20.0.49 255.255.255.252 > no ip redirects > no ip proxy-arp > ip policy route-map NEXT-HOP > no cdp enable > arp timeout 300 > end > ! > > ! > route-map NEXT-HOP permit 10 > match ip address 160 > set interface Serial1/0:0 > set ip next-hop 172.16.1.134 > ! > > ! > access-list 160 permit ip 172.20.0.48 0.0.0.3 any > ! > > Thanks > > *The router is a Cisco 3640 with CEF Enabled that works like MPLS-PE router. > > -- > Omar E.P.T > ----------------- > Certified Networking Professionals make better Connections! > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
