Hi Chris, Thanks for your reply. I try to configure the session in the ASA but it is not creating and showing the following error.
ciscoasa(config)# session 1 Opening command session with slot 1. Card in slot 1 did not respond to session request. Surpricingly, the 'Status' LED in the device is glowing stable green and power is also ok. Any clue plz. Regards, Kris. ----- Original Message ----- From: "ChrisSerafin" <[EMAIL PROTECTED]> To: "Krishna Kishore" <[EMAIL PROTECTED]> Cc: <[email protected]> Sent: Thursday, August 16, 2007 5:26 PM Subject: Re: [c-nsp] ASA 5510 - 4GE SSM Problem > It will not show up in the ASA configs. You need to 'session 1' i > believe into the device. This will log you into the SSM device. It has > it's own IP addressing and GUI. Think of it a separate device. > > Chris Serafin > Security Engineer > [EMAIL PROTECTED] > > > Krishna Kishore wrote: > > Hi All, > > > > I have a problem in installing 4 GE SSM module in my ASA 5510. I just bought a new module 4GE SSM and installed as per the instructions. But if I check in "sh run" I am not able to find the interfaces. Do I need to do extra any configurations? I try to check the Cisco site but I couldn't find a solution. > > > > Any clue to install it. > > > > Thanks in Advance, > > > > Kris. > > _______________________________________________ > > cisco-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/cisco-nsp > > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > > > > > > > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
