Make sure you are directly connected to router via a cross-over cable to eliminate and network latencies.
You may need to reload the IOS via the console port ... I recall that ROMMON mode is very restrictive inre: loading images. Make sure you set your console port to 38,400 baud and use the Y-Modem transfer method. This will take some time but it does work. I think you may also need to compress your flash if you've erased some images. It's also good to get into the habit of using FTP instead of TFTP to load images due to the file size limitations imposed by TFTP and the steady growth of Cisco IOS images. ----------------------------------------------- Hi all, I erased the flash and rebooted the router after reset I tried load the IOS in rommon mode, unfortunately the load didn't complete, I tried again and failed again, I thought tftp failure because I get TFTP timeout: !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!..!!!!.!!!!.!!!!.!!!.!. !!.!..!.!!.!!.!..!!.................. [TIMED OUT] TFTP: Operation terminated. After that I think that my flash memory is incorrect, how can I know if my flash is working well, or maybe is not working anymore!? Thanks for your response... PD. At this moment, my router is in rommon mode, and I don't know troubleshooting my flash... On 10/18/07, Jonathan Charles <[EMAIL PROTECTED]> wrote: > > Well, build a tarball of your IOS and CME files and just archive tar > /extract it to the flash > > > > Jonathan > > On 10/18/07, Adrian Chadd <[EMAIL PROTECTED]> wrote: > > On Thu, Oct 18, 2007, Jonathan Charles wrote: > > > Issue a format flash: > > > > > > It takes about 2 seconds and wipes it clean... > > > > > > Besides, no one uses SDM anyway... > > > > "oh crap all of my CME files are gone!" > > > > Its generally fine to start with, but then strange crap happens. Phones > > don't ring right, new phones don't get updated firmware, ATAs stop > working, > > etc. Then you swear. Loudly. :) > > > > (And squeeze flash isn't supported everywhere iirc.) > > > > > > > > Adrian > > > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > -- Omar E.P.T ----------------- Certified Networking Professionals make better Connections! _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
