Hi, On Dec 18, 2007, at 23:00, Dan Letkeman wrote:
Here is my config Switch configuration: interface FastEthernet0/1 switchport access vlan 500 switchport trunk native vlan 500 switchport trunk allowed vlan 160,200,500 switchport mode trunk The trunk is only showing 200 in forwarding state. I need 160 and 500 forwarded.
If you type on the upstream switch show interface ... trunk what does it really show? usually the vlans allowed on the trunk, vlans allowed and active and vlans in spanning-tree forwarding state and not pruned are identical. Do you have vlans created for 160 and 500 on the switch (assuming Cisco switch here)?
interface Dot11Radio0.160 encapsulation dot1Q 160 bridge-group 2 ! interface Dot11Radio0.500 encapsulation dot1Q 500 bridge-group 3 ! interface FastEthernet0.160 encapsulation dot1Q 160 bridge-group 2 ! interface FastEthernet0.500 encapsulation dot1Q 500 bridge-group 3 ! interface BVI1 ip address 192.168.50.151 255.255.255.0 no ip route-cache ! bridge 1 route ip ! I'm guessing there is something wrong with the bridge configuration.
Add: bridge 2 protocol ieee bridge 3 protocol ieee HTH Kaj -- Kaj J. Niemi <[EMAIL PROTECTED]> +358 45 63 12000
_______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
