Kaj, 2950#sh interfaces trunk
Port Mode Encapsulation Status Native vlan Fa0/1 on 802.1q trunking 500 Port Vlans allowed on trunk Fa0/1 160,200,500 Port Vlans allowed and active in management domain Fa0/1 160,200,500 Port Vlans in spanning tree forwarding state and not pruned Fa0/1 200 Dan. On Dec 18, 2007 3:29 PM, Kaj Niemi <[EMAIL PROTECTED]> wrote: > Hi, > > On Dec 18, 2007, at 23:00, Dan Letkeman wrote: > > > Here is my config > > > > Switch configuration: > > > > interface FastEthernet0/1 > > switchport access vlan 500 > > switchport trunk native vlan 500 > > switchport trunk allowed vlan 160,200,500 > > switchport mode trunk > > > > The trunk is only showing 200 in forwarding state. I need 160 and 500 > > forwarded. > > If you type on the upstream switch show interface ... trunk what does > it really show? usually the vlans allowed on the trunk, vlans allowed > and active and vlans in spanning-tree forwarding state and not pruned > are identical. Do you have vlans created for 160 and 500 on the switch > (assuming Cisco switch here)? > > > > interface Dot11Radio0.160 > > encapsulation dot1Q 160 > > bridge-group 2 > > ! > > interface Dot11Radio0.500 > > encapsulation dot1Q 500 > > bridge-group 3 > > ! > > interface FastEthernet0.160 > > encapsulation dot1Q 160 > > bridge-group 2 > > ! > > interface FastEthernet0.500 > > encapsulation dot1Q 500 > > bridge-group 3 > > ! > > interface BVI1 > > ip address 192.168.50.151 255.255.255.0 > > no ip route-cache > > ! > > bridge 1 route ip > > ! > > > > I'm guessing there is something wrong with the bridge configuration. > > > > Add: > > bridge 2 protocol ieee > bridge 3 protocol ieee > > > > > > HTH > > Kaj > -- > Kaj J. Niemi > <[EMAIL PROTECTED]> > +358 45 63 12000 > > > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
