Hi List, We cannot get Cat6500 to rewrite CoS values (802.1p bits).
Configuration is mls qos no mls flow ip no mls flow ipv6 no mls qos rewrite ip dscp no mls acl tcam share-global mls cef error action freeze interface GigabitEthernet2/1 switchport switchport trunk encapsulation dot1q switchport mode trunk no ip address load-interval 30 wrr-queue queue-limit 40 30 mls qos cos 5 no cdp enable spanning-tree portfast trunk no mls qos trust We have a sniffer connected to dot1q trunk on another port. The sniffer shows that 802.1p value for packets going out from Gig2/1 is set to 0. We have tried searching Cisco site and playing with various commands, but did not succeed. IOS 12.2(18)SXF5. Catalyst 3560 has "mls qos cos override" command, which seems to do the trick, but this command is not available on Catalyst 6500. -- Best Regards Vladimir Ivashchenko Chief Technology Officer PrimeTel, Cyprus - www.prime-tel.com _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
