Last time I did this, you had to use a 10GE port with the POS interface. You can then put the 10GE into another box and do a redirect to an etherchannel. You can even loop the 10GE back into the same router/switch if you so desire, but it gets a little more complicated.
David -- http://dcp.dcptech.com > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of > Michael K. Smith - Adhost > Sent: Tuesday, May 13, 2008 7:06 PM > To: [EMAIL PROTECTED] > Cc: [email protected] > Subject: Re: [c-nsp] SPAN for POS? > > Hello Jerry: > > ------------------------------------------------------- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] > Sent: Tuesday, May 13, 2008 8:58 AM > To: Michael K. Smith - Adhost > Cc: [email protected] > Subject: Re:[c-nsp] SPAN for POS? > > Yes, use the switchport capture feature. > > http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/ > 12.2SX/configuration/guide/sx_swcg.pdf > create the VACL first and then set a switchport as "capture". > > You can apply the VACL to a WAN interface. > > Thanks, > Jerry > ---------------------------------------------------------------------- > > If you're pushing a full OC-48 worth of bandwidth would you > have to have a 10 Gig switchport or could you use an > etherchannel of 3 ports? The way I read Hank's message he > needs to capture the full 2.5 Gbps. Nice workaround though. > > Regards, > > Mike > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
