> On some platforms, "conf t" +"no arp a.b.c.d" can do this, but I > haven't tried it on ME6524. Is "clear arp interface <xxx>" where <xxx> > is the interface where the arp entry is located won't probably be that > hard, unlesss you have thousand of entries on that routed or SVI > interface.
"no arp a.b.c.d" doesn't work :( "clear arp x.x.x.x" doesn't exist either. "clear arp-cache interface GigabitEthernet 1/10" is not clearing arp entries from GigabitEthernet1/10.215 > > >> How to display mac learned on a routed subinterface >> "sh mac-address-table" don't display mac addresses for ports like Gi1/10.200 > > I don`t think routed subinterfaces have mac-address-table, by > definition... ping <broadcast address of Gi1/10.200> (use both > all-zeros and all-ones broadcasts) followed by show ip arp gi1/10.200 > will likely show whoever is attached to that interface (even for hosts > that don't answer ping, because it's not common to filter out arp > requests/responses in host firewalls these days). > > > Rubens Ok ! But the box is still a switch. It uses internal vlans. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
