There were some platforms like the 7500 where "no arp" in config mode did work for dynamic ARP entries.
As I said, I haven't tested it on the ME6524, neither with SVIs or routed interfaces, neither with ZU2 or SXH IOS. An ARP entry associated with DHCP Snooping / Dynamic ARP Inspection / IP Source Guard may also show a different behavior than a pure dynamic ARP entry. Rubens 2008/8/12 Tassos Chatzithomaoglou <[EMAIL PROTECTED]>: > > Justin, "no arp" in config mode should work for static entries only. > > -- > Tassos > > Justin Shore wrote on 12/8/2008 4:17 μμ: >> >> The argument for clear arp-cache is an interface or null. >> >> 6524-2.brd#clear arp-cache ? >> interface Clear the entire ARP cache on the interface >> <cr> >> >> Ruben was correct with 'no arp <ip>' from global config mode on that >> platform with the ZU code. >> >> Justin >> >> >> Tassos Chatzithomaoglou wrote: >>> >>> "clear arp-cache x.x.x.x" should work. Just keep in mind that after doing >>> this, the local router will send an arp request to this mac. If it's still >>> active, a reply is sent back and the local arp table will be filled again >>> (you can check the "Age" counter). >>> >>> -- >>> Tassos >> >> > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
