They claimed they don't provide clocking on point to point circuit...not even for testing sake! We did played around with both side getting network timing, with switching the side providing clocking, with both going internal...etc, but nothing worked. It only works for some hours after they break in the circuit for testing.
Luan Nguyen Chesapeake NetCraftsmen, LLC. www.NetCraftsmen.net -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Lamar Owen Sent: Wednesday, October 15, 2008 10:37 AM To: [email protected] Subject: Re: [c-nsp] OK, what is a cheap and dirty hack to test a port On Wednesday 15 October 2008 10:22:17 Luan Nguyen wrote: > Is it a Verizon circuit? > We have a T1 circuit with Verizon and have the same problem. We have a > point to point circuit, so one side has clocking set to internal to provide > the clocking and the other side feeds from the line. Have you tried setting the clock to line on the side where you have the clock set to internal? Some point to point T1's still need both CPE's to have clock set to line. I don't have a point to point T1, but I do have a point to point OC3, and in that case clock must be set to line on both ends, as the network provides the clock. -- Lamar Owen Chief Information Officer Pisgah Astronomical Research Institute 1 PARI Drive Rosman, NC 28772 http://www.pari.edu _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
