Moving the Target Noise Margin or whatever it is called in your DSLAM is a better plan.
Interleaving has far more to do with sync stability, i.e. it allows the router some time to respond to changes in the line quality before loosing the sync, it also increases latency. The more interleaving time you allow, the greater the latency, but then again, better sync stability. I would use both, interleave at a low setting, and a higher target noise margin if you're running sensitive services such as IPTV over the line. 4ms interleave + 9dB target noise margin should leave the line relatively stable. If you find the maximum sync speed of the line moves below your set minimum to offer the service when you're at 9dB (the higher the target noise margin the lower the sync speed), the line probably isn't good enough to offer the service to begin with. BR, Sibbi On 2.2.2009 09:56, "Tim Franklin" <[email protected]> wrote: > Ziv Leyes wrote: > >> Setting interleave in the DSLAM will do automatically what I proposed >> before, lowering the speed of the link in order to improve line >> quality. > > Be careful with what you mean by "speed" in this instance. Interleaving > typically increases latency, rather than reducing bandwidth. > > Regards, > Tim. > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
